What are the installation conditions for the hanging plate of the linear vibrating screen and the screen mesh

Linear vibrating screen understands equipment as a rectangular state from linear words. This type of vibrating screen is mainly a general term for rectangular vibrating screens. During the operation, the material will jump forward on the screen surface and run in a linear form. There are many ways to install this vibrating screen. What are the installation conditions for the hook plate of the linear vibrating screen screen? Today, I will mainly discuss which is suitable for installing screens with hook plate structures. What are the benefits of hook plate structure?

1. Requirements for vibrating screens with hook plate structures:

The installation method of hook screen has fixed regulations on the wire diameter of the mesh holes. The hook plate structure should not use screens with smaller mesh diameters and smaller wire diameters. Although the hook plate structure can be used to tighten fine wire mesh, it can also increase production, but there is no supporting mesh below the sieve plate of the hook plate steel structure. Easy to make the sieve unable to withstand the net weight and cracks of the raw materials. The sieve structure of the hook plate structure cannot be installed together with the bouncing ball cleaning equipment. If the sieve is very small, it is easy to block the mesh. If the diameter of the wire is too thick, there is no need to choose a mesh type installation method. The wire diameter is too shallow and tightly packed on both sides. Unable to delete it. Disassembling the screen is more inconvenient.

2. Adjustment of the number of overlapping layers of the sieve mesh by the hook plate vibrating screen:

The installation method of hook screen is usually not very specific to the number of layers of vibrating screen, but you will not see that the hook plate is installed with too many layers of screen. Very likely to cause inconvenience in disassembling the next layer of screen. Under normal circumstances, the next layer of screens is denser, the screens are denser, and it is easier to damage them. The ones above are relatively rough when moving. Therefore, the upper screen has a longer service life. When removing the lower screen, the upper screen must be replaced. The entire process of replacing the filter can only be carried out after removing the mosquito net. It will bring some inconvenience to manufacturing.

A vibrating screen with a hook plate structure is a design scheme method without a ball grid, which can reasonably increase the opening rate of the screen, and can also reasonably increase the output and accuracy of the vibrating screen. You should purchase this type of installation method and contact the vibrating screen manufacturer. Convenient manufacturing design solutions.